Product description
2 You can use special screws, one: a short screws with washer screw can be common, cost-effective.
3 tracks easy to adjust, track screw machine can be withdrawn freely adjust, easy to understand, easy to operate.
4.-free card screws phenomenon, screw in the cylinder exercise fall fight, who did not enter the orbit of the screws have been removed to the drum into the next cycle.
5 be free to adjust the size of the working speed
6 to change the vibration intensity by adjusting the speed of the screw reaches the position taken before and after the shake will not affect the work efficiency.
7 fault alarm function.
Feeding 8 independent control and vibration drive, can freely set the desired stop time delay, when extraordinary circumstances produce, screws opportunity boot failure alarm.
9 new adjustable screw machine TES-1050, the operation is as simple, and other screw machine.产品Specification
RDE-1050
|
|
123(W)X181(D)X145(H |
|
Weight |
2.92kg |
Power supply |
DC12V 500mA |
Automatic stop |
Lined screw stops automatically after |
Screw |
NSB M10-M3.0 |
Applicable length |
Max 20mm |
Capacity |
80cc |
Accessories |
L-shaped hex key |
Adjustment screw machine count
1. Interface Description:
As shown above, the number for the screw properly displayed.
2. Function Keys:
There are four function keys,
First layer: press the function key and hold for 3 seconds, the digital display numbers flashing, then press the up or down arrow keys to set the number of each of the screws, the adjustment range 0-9999;
Second layer: press the function key and hold for 3 seconds, the digital display numbers flashing, then press the up or down arrow keys to set the operating mode, an automatic, two manual, three consecutive counts no alarm.
Under the automatic mode of operation, when the screw reaches the set number, alarm sound, then automatically starts counting from 1.
Under the manual mode, when the screw reaches the set number, alarm sound, screw machine stops feeding until you manually press the function key, before resetting again the next cycle.
Continuous work, namely continuous counting, to set the number nor the police, nor stop.
Third layer: for a normal screw, a screw feed speed, when it reaches the set number because of inertia of the screw may be more, so reducing the number of required until reaching the set speed of the screw to exert, in order to reduce inertia. When this layer to set a number, this number is reached the feed rate is reduced. Press the Up or Down keys to adjust the quantity.
Fourth layer: This layer is used to adjust the feed rate to reach out after the set number of the third layer. Press the Up or Down keys to adjust the speed.
Press the function key again and hold for 3 seconds to return to normal working condition.
3. Check out the total number of screws
After working for some time, to see out of the total number of screws, press and hold to reduce key, you can display the total number.
4. Also, note that when you install a stationary chute, one must ensure that the gap must be left between about 0.5mm and still vibrating chute slide, otherwise the material will not function properly.
5. Other adjustment method, see generic description.
Contact: Winson Yang
Phone: 008619941451990
Tel: 008619941451990(WhatsApp)
Email:
Add: Zhenhai Zhuangshi street Xingzhuang Road No.9 Chuang e Huigu Building 42 Building B Room 408